Performance Analysis of Diesel Engine with Blends of Waste Vegetable Oil and Diesel

Submission Deadline-30th July 2024
June 2024 Issue : Publication Fee: 30$ USD Submit Now
Submission Deadline-20th July 2024
Special Issue of Education: Publication Fee: 30$ USD Submit Now

International Journal of Research and Scientific Innovation (IJRSI) | Volume VIII, Issue IV, April 2021 | ISSN 2321–2705

Performance Analysis of Diesel Engine with Blends of Waste Vegetable Oil and Diesel

Sangem Sarangapani
Senior Lecturer in Mechanical Engineering, Government polytechnic Kataram, India*

IJRISS Call for paper

Abstract: Diesel engines are generally heavy duty vehicles used in transportation and agricultural sectors. Diesel engines meet their energy requirement from natural petroleum products. The problems associated with diesel fuels are their increasing price, atmospheric pollution and lack of sufficient availability in next few years. The vegetable oils stands as alternate fuels for natural fuels as physical and combustion properties are close to the diesel fuel. However the viscosity of the vegetable oils is higher than diesel fuel. In the present investigation waste sunflower oil is taken as alternate fuel. The high viscosity of sun flower oil is decreased by blending with diesel in various proportions and heated prior to the combustion in the cylinder. The fuel blends were heated by means of the cooling water of the engine. The blends of the varying proportions of sunflower oil and diesel were prepared, analysed and compared with diesel fuel. The effect of temperature on the viscosity of fuel blends was also studied. The performance of the engine using fuel blends were evaluated in a single cylinder C I engine and compared with the performance obtained with the pure diesel. The experiments were performed on the four stroke engine at various loads by maintaining constant speed. The fuel blends supplied to the engine are S 10 (10% of sunflower oil and 90% of diesel), S 25, S 50.It is observed that the performance of the engine is almost same up to S 25 fuel blend without much preheating, compared to pure diesel engine. The maximum brake thermal efficiency obtained is 30.3% for S 25 blend while it is 32.6% for pure diesel. The brake specific fuel consumption and maximum exhaust temperature obtained were 0.262 kg/kWh and 292 C respectively for S 25 fuel blend, while they are 0.248 kg/kWh and 242 C for pure diesel.

Keywords: vegetable oil blends with diesel, bsfc, brake thermal efficiency and exhaust gas temperature

I. INTRODUCTION

Due to gradual depletion of world petroleum reserves and the impact of environmental pollution of increasing exhaust emissions, there is a need for suitable alternate fuels for use in diesel engines. In view of this, vegetable oil is a promising alternative, because it has several advantages like it is renewable, environmental friendly, nontoxic and biodegradable. In addition to this it is produced easily in rural areas, where there is a need for modern forms of energy. Therefore, in recent years systematic efforts have been made by several researchers to use vegetable oils as fuels in engines. In the year 1900 Rudolf diesel demonstrated a new engine that run on a peanut oil. In 1912 Rudolf diesel stated that the use of vegetable oils for engine fuels may seem insignificant today, but such oils may become in course of time as important as petroleum products of present time.