A Socio-Technical Evaluation of Real-Time Room-Level IoT Feedback in Tropical Residential Environments

Authors

Nurul Fatiha Binti Johan

Center of Robotics and Industrial Automation, Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (Malaysia)

Ahmad Hilman Bin Mohamad Hasbi

Center of Robotics and Industrial Automation, Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (Malaysia)

Nursabillilah Binti Mohd Ali

Center of Robotics and Industrial Automation, Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (Malaysia)

Mohd Safirin Bin Karis

Faculty of Electronics and Computer Technology and Engineering, Universiti Teknikal Malaysia Melaka (Malaysia)

Article Information

DOI: 10.47772/IJRISS.2026.101100070

Subject Category: Environment

Volume/Issue: 10/11 | Page No: 1041-1052

Publication Timeline

Submitted: 2026-10-31

Accepted: 2026-11-05

Published: 2026-11-20

Abstract

Escalating electricity demand in tropical urban residences poses severe challenges to energy sustainability and household financial well-being. In Malaysia, residential electricity consumption has experienced an average annual growth rate of 3.4%, driven by rising living standards and increased adoption of high-power appliances. Most electricity bills only show the total amount of energy used at the end of the month. As a result, homeowners cannot easily identify which rooms or appliances are wasting electricity. This paper presents a low-cost Internet of Things (IoT) system that monitors electricity usage at the room level while also providing electrical protection. The system uses an ESP32 microcontroller, PZEM-004T sensors, and the Blynk mobile platform to measure voltage, current, power consumption, and energy usage for individual room circuits. Users can view real-time data on their smartphones, while the system automatically disconnects the power supply if an overload occurs. The system was evaluated through Proteus 8 simulation to verify control logic and subsequently validated via 24-hour physical hardware deployment across two residential socket circuits (Channel 1 and Channel 2). Hardware results demonstrate accurate dual-channel monitoring at stable mains voltage (~240V AC), recording 15 W (1.04 kWh) for Channel 1 and 37.0 W (0.70 kWh) for Channel 2 under normal load. Hardware overload testing confirmed instant relay tripping and push notification generation within 1.2 to 2.5 seconds when active power exceeded the preset 3,500 W limit. Beyond energy monitoring, this study highlights how affordable smart metering technology can improve public awareness of electricity usage, encourage energy-saving habits, and enhance household safety. Grounded in residential energy feedback literature, such real-time feedback systems offer the potential to assist households in reducing electricity consumption by approximately 12% to 18%, presenting a practical and affordable solution for middle- and lower-income communities without requiring costly upgrades to existing electrical infrastructure.

Keywords

socio-technical systems, IoT energy monitoring, smart sub-metering, household safety, residential energy management.

Downloads

References

1. Abdullah, E., et al. (2021). Development of real-time energy monitoring system and data log using NodeMCU ESP8266 and MYSQL database (ResearchGate Technical Report). [Google Scholar] [Crossref]

2. Aldhshan, S. R. S., et al. (2021). Energy consumption and spatial assessment of renewable energy penetration and building energy efficiency in Malaysia: A review. Sustainability , 13(16), Article 9295. [Google Scholar] [Crossref]

3. Allegro MicroSystems, LLC. (2025). ACS712 fully integrated, Hall-effect-based linear current sensor IC datasheet . Worcester, MA. [Google Scholar] [Crossref]

4. Azlina, A. A., et al. (2015). Energy conservation of residential sector in Malaysia. Journal of Business and Social Development , 3(2), 1–10. [Google Scholar] [Crossref]

5. Azlina, A. A., et al. (2016). Factors influencing household end-use electricity demand in Malaysia. Advanced Science Letters , 22(12), 4203–4207. [Google Scholar] [Crossref]

6. Boomsma, M., Vringer, K., & van Soest, D. (2025). The impact of real-time energy consumption feedback on residential gas and electricity usage. Journal of Environmental Economics and Management , 132, Article 103012. [Google Scholar] [Crossref]

7. BSI. (2010). Safety requirements for electrical equipment for measurement, control, and laboratory use (BS EN 61010-1). British Standards Institution, London. [Google Scholar] [Crossref]

8. Chen, Z., Wang, F., & Feng, Q. (2016). Cost-benefit evaluation for building intelligent systems with special consideration on intangible benefits and energy consumption. Energy and Buildings , 128, 485–495. [Google Scholar] [Crossref]

9. Daud, S., et al. (2023). Residential consumers' lifestyle energy usage and energy efficiency in selected states in Malaysia. Energies , 16(8), Article 3412. [Google Scholar] [Crossref]

10. Dinata, I., & Sunanda, W. (2015). Implementasi wireless monitoring energi listrik berbasis web database. Jurnal Nasional Teknik Elektro , 4(1), 85–92. [Google Scholar] [Crossref]

11. Energy Commission. (2011). Non-domestic electrical installation safety code . Suruhanjaya Tenaga, Putrajaya, Malaysia. [Google Scholar] [Crossref]

12. Energy Commission. (2025). Electrical energy consumption and statistics listing . Suruhanjaya Tenaga, Putrajaya, Malaysia. [Google Scholar] [Crossref]

13. Espinosa-Gavira, M. J., et al. (2024). Characterization and performance evaluation of ESP32 for real-time synchronized sensor networks. Procedia Computer Science , 237, 412–419. [Google Scholar] [Crossref]

14. Fletcher, J., & Malalasekera, W. (2016). Development of a user-friendly, low-cost home energy monitoring and recording system. Energy , 111, 668–678. [Google Scholar] [Crossref]

15. Google. (2025). Firebase Realtime Database documentation . Mountain View, CA. [Google Scholar] [Crossref]

16. Grafana Labs. (2025). Grafana: The open and composable observability platform . New York, NY. [Google Scholar] [Crossref]

17. Grossi, M. (2024). Efficient and accurate analog voltage measurement using a direct sensor-to-digital port interface for microcontrollers and field-programmable gate arrays. Sensors , 24(3), Article 891. [Google Scholar] [Crossref]

18. Hasan, M. R., Hossain, E., Resalat Faruque, H. M., & Sultan, T. (2019). IoT based smart energy management in residential applications. In Proceedings of the 2019 International Conference on Advances in Science, Engineering and Robotics Technology (ICASERT 2019) . IEEE. [Google Scholar] [Crossref]

19. Huang, L. C., Chang, H. C., Chen, C. C., & Kuo, C. C. (2011). A ZigBee-based monitoring and protection system for building electrical safety. Energy and Buildings , 43(6), 1426–1433. [Google Scholar] [Crossref]

20. Lianda, J., Handarly, D., & Adam, A. (2019). Sistem monitoring konsumsi daya listrik jarak jauh berbasis Internet of Things. JTERA (Jurnal Rekayasa Teknologi) , 4(1), 79–84. [Google Scholar] [Crossref]

21. MathWorks. (2025). IoT analytics - ThingSpeak Internet of Things platform . Natick, MA. [Google Scholar] [Crossref]

22. Mendez-Monroy, P. E., et al. (2022). IoT system for the continuous electrical and environmental monitoring into Mexican social housing evaluated under tropical climate conditions. Journal of Sensors , 2022, Article 4819201. [Google Scholar] [Crossref]

23. Mudaliar, M. D., & Sivakumar, N. (2020). IoT based real time energy monitoring system using Raspberry Pi. Internet of Things , 12, Article 100292. [Google Scholar] [Crossref]

24. Pandansari, F., Prasetyo, H., & Tularsih, Y. T. (2021). Analisa pengembangan sistem pemantau daya listrik berbasis IoT. Jurnal Teknik , 19(2), 112–119. [Google Scholar] [Crossref]

25. Patnaikuni, D. R. P. (2017). A comparative study of Arduino, Raspberry Pi and ESP8266 as IoT development board. International Journal of Advanced Research in Computer Science , 8(5), 2350–2355. [Google Scholar] [Crossref]

26. Peacefair. (2025). PZEM-004T AC multi-function electric energy metering power monitor user manual . Ningbo, China. [Google Scholar] [Crossref]

27. Sabillah, L., & Hidayat, R. (2023). Sistem monitoring pemakaian energi listrik pada kamar kost menggunakan aplikasi Blynk berbasis Internet of Things. Jurnal Komputer dan Elektro Sains , 1(1), 14–20. [Google Scholar] [Crossref]

28. Salah, W. A., & Zneid, B. A. (2019). Evolution of microcontroller-based remote monitoring system applications. International Journal of Electrical and Computer Engineering (IJECE) , 9(4), 2354–2363. [Google Scholar] [Crossref]

29. Shafiullah, M., et al. (2022). Review of smart city energy modeling in Southeast Asia. Smart Cities , 6(1), 66–99. [Google Scholar] [Crossref]

30. Simadiputra, V., & Surantha, N. (2021). Rasefiberry: Secure and efficient Raspberry-Pi based gateway for smarthome IoT architecture. Bulletin of Electrical Engineering and Informatics , 10(2), 1023–1031. [Google Scholar] [Crossref]

31. Swathi, K., Sandeep, T. U., & Ramani, A. R. (2018). Performance analysis of microcontrollers used in IoT technology. International Journal of Scientific Research in Science, Engineering and Technology (IJSRSET) , 4(1), 890–895. [Google Scholar] [Crossref]

32. Texas Instruments Inc. (2008). INA219 zero-drift, bidirectional current/power monitor datasheet . Dallas, TX. [Google Scholar] [Crossref]

33. Vannieuwenborg, F., Verbrugge, S., & Colle, D. (2018). Choosing IoT-connectivity? A guiding methodology based on functional characteristics and economic considerations. Transactions on Emerging Telecommunications Technologies , 29(3), Article e3244. [Google Scholar] [Crossref]

Metrics

Views & Downloads

Similar Articles