Design and Development of an Atmospheric Water Harvesting System Using Solar-Powered Thermoelectric Cooling for Hot and Humid Water-Scarce Areas

Authors

Aiman Danial Sulong

Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (UTeM), 76100 Durian Tunggal, Melaka (Malaysia)

Emy Zairah Ahmad

Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (UTeM), 76100 Durian Tunggal, Melaka (Malaysia)

Amalia Aida Abd Halim

Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (UTeM), 76100 Durian Tunggal, Melaka (Malaysia)

Nurul Ashikin Mohd Rais

Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (UTeM), 76100 Durian Tunggal, Melaka (Malaysia)

Intan Mastura Saadon

Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (UTeM), 76100 Durian Tunggal, Melaka (Malaysia)

Nurul Kausar Ab Majid

Faculty of Electrical Technology and Engineering, Universiti Teknikal Malaysia Melaka (UTeM), 76100 Durian Tunggal, Melaka (Malaysia)

Article Information

DOI: 10.47772/IJRISS.2026.100800844

Subject Category: Social science

Volume/Issue: 10/8 | Page No: 12424-12429

Publication Timeline

Submitted: 2026-08-10

Accepted: 2026-08-15

Published: 2026-09-18

Abstract

Atmospheric Water Harvesting (AWH) using Solar-Powered Thermoelectric Cooling (TEC) offers a decentralised, renewable means of extracting water vapour from humid air in hot, water-scarce regions. A major challenge in AWH is achieving efficient, low-maintenance cooling to condense moisture, a need that TEC modules address through their solid-state reliability. This study designs, develops and evaluates an AWH prototype that integrates a TEC module, a copper coil condenser, DC cooling fans, a water circulation pump and a solar-battery power supply to analyze temperature behavior, water collection and energy efficiency. Ambient water is circulated through the TEC to cool a copper coil below the dew point, inducing continuous condensation. The prototype was tested inside a sealed chamber over one-hour operating periods to compare copper coil orientation, coolant flow rate, and daytime versus night-time operation. Results show the horizontal copper orientation achieved a more uniform, lower steady-state surface temperature (20.5-21.0°C) than the vertical orientation (21.5-22.5°C), producing 55.4 mL of water compared to 33.0 mL, an increase of about 68%. Raising the coolant flow rate from 600 L/h to 1000 L/h increased water yield from 55 mL to 94 mL, while 800 L/h gave the lowest average copper surface temperature (21.1°C). Night-time operation consistently outperformed daytime operation, collecting an average of 83 mL compared to 76 mL, owing to lower ambient temperature and higher relative humidity. The system achieved a peak yield of 94 mL/h, comparing favorably with similar TEC-based AWH prototypes reported in the literature. Overall, the developed system demonstrates reliable, energy-efficient performance under hot and humid tropical conditions, supporting its potential as a practical, off-grid solution for atmospheric water harvesting in water-scarce areas.

Keywords

Atmospheric Water Harvesting, Thermoelectric Cooling, Solar Energy, Condensation, Copper Coil Condenser

Downloads

References

1. A. Anowar, S. U. Nayeem, and S. S. Wriddhi, “Alternative source of water using atmospheric water generator by using thermoelectric cooling method and its potential use for sustainable development,” 2024. [Google Scholar] [Crossref]

2. Z. Djafar et al., “Atmospheric Water Harvesting Using Thermoelectric Cooling Technology,” Int. J. Des. Nat. Ecodynamics, vol. 18, no. 4, pp. 1011–1016, 2023. https://doi.org/10.18280/ijdne.180430 [Google Scholar] [Crossref]

3. T. J. Kadhim, A. K. Abbas, and H. J. Kadhim, “Experimental study of atmospheric water collection powered by solar energy using the Peltier effect,” IOP Conf. Ser. Mater. Sci. Eng., vol. 671, no. 1, 2020. https://doi.org/10.1088/1757-899X/671/1/012155 [Google Scholar] [Crossref]

4. G. Raveesh, R. Goyal, and S. K. Tyagi, “Advances in atmospheric water generation technologies,” Energy Convers. Manag., vol. 239, p. 114226, 2021. https://doi.org/10.1016/j.enconman.2021.114226 [Google Scholar] [Crossref]

5. A. Riahi et al., “Performance investigation of 18 thermoelectric cooler (TEC) units to supply continuous daily fresh water from Malaysia’s atmosphere,” Sustainability, vol. 13, no. 3, pp. 1–16, 2021. https://doi.org/10.3390/su13031399 [Google Scholar] [Crossref]

6. S. Sanaye, A. Shourabi, and D. Borzuei, “Sustainable water production with an innovative thermoelectric-based atmospheric water harvesting system,” Energy Reports, vol. 10, pp. 1339–1355, 2023. https://doi.org/10.1016/j.egyr.2023.07.062 [Google Scholar] [Crossref]

7. B. Tashtoush and A. Y. Alshoubaki, “Solar-off-grid atmospheric water harvesting system: Performance analysis and evaluation in diverse climate conditions,” Sci. Total Environ., vol. 906, p. 167804, 2024. https://doi.org/10.1016/j.scitotenv.2023.167804 [Google Scholar] [Crossref]

8. J. Wang, Y. Suo, H. Lou, Y. Ye, and Z. Zhang, “Optimization of a thermoelectric cooler-based system for atmospheric water production in terms of temperature of condensing surface,” Case Stud. Therm. Eng., vol. 54, p. 104000, 2024. https://doi.org/10.1016/j.csite.2024.104000 [Google Scholar] [Crossref]

9. J. Wang, Z. Yang, Z. Li, H. Fu, and J. Chen, “Comprehensive review on atmospheric water harvesting technologies,” J. Water Process Eng., vol. 69, p. 106836, 2025. https://doi.org/10.1016/j.jwpe.2024.106836 [Google Scholar] [Crossref]

Metrics

Views & Downloads

Similar Articles