Experimental Study of Electrical Energy Generation Using a Simple Aluminum-Carbon Electrochemical Cell in Saline Solution

Authors

Léandre Mathias Vissoh

Laboratoire de Procédés et d’innovations Technologiques (LaPIT) /Université Nationale des Sciences, Technologies, Ingénierie et Mathématiques d’Abomey (UNSTIM) (Benin)

Agnimoan Constant Alihonou

Laboratoire de Procédés et d’innovations Technologiques (LaPIT) /Université Nationale des Sciences, Technologies, Ingénierie et Mathématiques d’Abomey (UNSTIM) (Benin)

Jules Anicet S. Yamonche

Laboratoire de Procédés et d’innovations Technologiques (LaPIT) /Université Nationale des Sciences, Technologies, Ingénierie et Mathématiques d’Abomey (UNSTIM) (Benin)

Alain C. N. Adomou

Laboratoire de Procédés et d’innovations Technologiques (LaPIT) /Université Nationale des Sciences, Technologies, Ingénierie et Mathématiques d’Abomey (UNSTIM) (Benin)

Article Information

DOI: 10.47772/IJRISS.2026.1026EDU0047

Subject Category: Science

Volume/Issue: 10/26 | Page No: 594-600

Publication Timeline

Submitted: 2026-01-20

Accepted: 2026-01-26

Published: 2026-01-31

Abstract

This study investigates the feasibility of electrical energy generation using a low-cost aluminum–carbon electrochemical cell operating in a saline electrolyte. The experimental setup consisted of aluminum foil as an anode, a carbon rod as a cathode, and a NaCl aqueous solution. Electrical performance was monitored over a three-week period through voltage and current measurements. The system produced an initial open-circuit voltage of up to 20 V and was capable of powering a low-power load. However, the output current remained limited (0.015–0.033 A), significantly restricting practical applications. Strong voltage fluctuations were observed, particularly during morning measurements, with a minimum voltage of 5.8 V, attributed to electrode degradation and electrolyte depletion. Despite these limitations, the system demonstrates potential for educational purposes and low-power backup applications. The integration of a battery storage system improved supply continuity. The study highlights both the feasibility and intrinsic limitations of rudimentary aluminum-based electrochemical energy systems.

Keywords

Electrochemistry; Aluminum-based cells; Saline electrolyte; Low-cost energy systems; Voltage instability

Downloads

References

1. Batribox. (2025). Bilan environnemental du recyclage des piles. https://www.batribox.fr [Google Scholar] [Crossref]

2. Bard, A. J., & Faulkner, L. R. (2001). Electrochemical methods: Fundamentals and applications (2nd ed.). Wiley. [Google Scholar] [Crossref]

3. Centre National de la Recherche Scientifique (CNRS). (2020). La pile électrochimique : Principes et applications. CNRS Éditions. [Google Scholar] [Crossref]

4. Fontana, M. G. (2005). Corrosion engineering (3rd ed.). McGraw-Hill. [Google Scholar] [Crossref]

5. HW-ALU. (2023). Aluminium : Composition, propriétés et applications. https://www.hw-alu.com [Google Scholar] [Crossref]

6. International Energy Agency. (2023). World energy outlook 2023. IEA. [Google Scholar] [Crossref]

7. Linden, D., & Reddy, T. B. (2011). Handbook of batteries (4th ed.). McGraw-Hill. [Google Scholar] [Crossref]

8. Trasatti, S. (1984). Electrocatalysis in the anodic evolution of oxygen. Electrochimica Acta, 29(11), 1503–1512. https://doi.org/10.1016/0013-4686(84)85004-5 [Google Scholar] [Crossref]

9. Wang, Y., & Sun, Z. (2019). Performance analysis of aluminum-based electrochemical cells in saline electrolytes. Electrochimica Acta, 296, 925–933. https://doi.org/10.1016/j.electacta.2018.11.123 [Google Scholar] [Crossref]

10. Xu, J., & Zhang, H. (2020). Challenges and perspectives of aluminum-based batteries. Energy Storage Materials, 25, 107–120. https://doi.org/10.1016/j.ensm.2019.08.020 [Google Scholar] [Crossref]

11. Yang, S., & Knickle, H. (2018). Aluminum–air batteries: Fundamentals and applications. Journal of Power Sources, 389, 35–48. https://doi.org/10.1016/j.jpowsour.2018.04.038 [Google Scholar] [Crossref]

12. Li, J. (2020). Copper–zinc battery’s performance with different electrolytes. Independent Research Report. [Google Scholar] [Crossref]

13. https://pdfs.semanticscholar.org/d4c6/076dbbef17785e6640c8b6d99bb70dd864a6.pdf. [Google Scholar] [Crossref]

14. Mainar, A. R., Colmenares, L. C., Leonet, O., Bengoechea, M., Boyano, I., & Iruin, E. (2017). An overview of progress in electrolytes for secondary zinc–air batteries. Journal of Energy Storage, 15, 304–328. https://doi.org/10.1016/j.est.2017.10.011 [Google Scholar] [Crossref]

15. Shin, C., Park, J., Kim, H., & Lee, S. (2024). Zinc–copper dual-ion electrolytes to suppress dendritic formation and improve electrochemical stability. Journal of Electrochemical Science, 171(2), 020501. [Google Scholar] [Crossref]

16. Oulmas, C., Rkik, A., Achour, M. E., & Abouliatim, Y. (2019). Comparative study of Cu–Zn coatings electrodeposited from sulphate and chloride baths. Heliyon, 5(11), e02703. [Google Scholar] [Crossref]

17. https://doi.org/10.1016/j.heliyon.2019.e02703. [Google Scholar] [Crossref]

18. Tang, W.-Q., Zhu, J.-Y., Sun, H., Juan, Y.-F., Fu, C.-P., Yang, J., & Zhang, J. (2024). Mechanism of catalyst on morphological evolution of Al(OH)₃ during Al–H₂O reaction. Transactions of Nonferrous Metals Society of China, 34(4), 1347–1364. [Google Scholar] [Crossref]

19. Wang, T., Zhu, Y., Li, X., Zhang, H., & Chen, Z. (2023). Investigation of commercial aluminum alloys as anode materials for alkaline aluminum–air batteries. Sustainable Energy [Google Scholar] [Crossref]

Metrics

Views & Downloads

Similar Articles