Solar Cell Photovoltaic Model Shell Sp 75

Authors

K.B. Bencherif

University of the Abdelhamid Ibn Badis Mostaganem (Algeria)

H.A. Bentounes

University of the Abdelhamid Ibn Badis Mostaganem (Algeria)

L. Ghomri

University of the Abdelhamid Ibn Badis Mostaganem (Algeria)

Article Information

DOI: 10.51244/IJRSI.2025.120800136

Subject Category: Engineering & Technology

Volume/Issue: 12/8 | Page No: 1564-1568

Publication Timeline

Submitted: 2025-06-07

Accepted: 2025-06-12

Published: 2025-09-15

Abstract

For the calculation of the voltage and current of the PV model ,several theoretical models have been developed. In this work, we presented a simple model to a single exponential. The photovoltaic model is typically represented by an equivalent circuit and parameters are calculated experimentally .Using Matlab as a tool for simulation ,we have considered three sizes :short-circuit, open circuit voltage, voltage and current at maximum power point of the photovoltaic model characteristics shell SP 75 in condition standard test .The results were compared with those provided by other researchers.

Keywords

Photovoltaic model-specific parameters of the characteristics IV Crystalline-Si- Solar Cell-Models.

Downloads

References

1. T.U. Townsed, ‘A Method for Estiming the Long Term Perfermance of Direct-Coupled Photovoltaic Systems’, MS Thesis, Solar Energy Laboratory, University of Wisconsin, Madison, 1989. [Google Scholar] [Crossref]

2. W.L.De Soto, ‘Improvement and Validation of a Model for Photovoltaic Array Perfermance’, MS Thesis, Solar Energy Laboratory, University of Wisconsin- Madison, 2004. [Google Scholar] [Crossref]

3. F. Bryan, ‘Simulation Sof Grid-Tied Building Integrated Photovoltaic Systems’, MS Thesis, Solar Energy Laboratory, University of Wisconsin, Madison 1999. [Google Scholar] [Crossref]

4. D. Chan and J. Phang,’Analytical Methods for the Extraction of Solar Cell Single- and Double-Diode Model Parameters from I-V Characteristics’, IEEE Transactions on Electron Devices, Vol. 34, N°2, pp.286 – 293, 1987 . [Google Scholar] [Crossref]

5. D. Sera , R. Teodorescu and P. Rodrigez, ‘PV Panel Model Based on Datacheet Values’, ISIE-07, IEEE International Symposium on Industrial Electronics, pp. 2392 – 2396, 2007. [Google Scholar] [Crossref]

6. G.R. Walker, ‘Evaluating MPPT Converter Topologies using a MATLAB PV Model’, Journal of Electrical & Electronics Enginnering, Australia, IEAust, Vol. 21, N°1, pp. 49-56, 2001. [Google Scholar] [Crossref]

7. R. Khezzar, M Zereg et A. Khezzar, ‘Comparaison Entre Les DifferentsModéles Electriques et Détermination des Paramétres de la Caractéristique I-V d’un Module Photovoltaique’ Revue des Energies Renouvelables Vol. 13 N°3 (2010) 379-388 . [Google Scholar] [Crossref]

8. J. Cabestany and L. Castaner,’Evalution of Solar Cell Parameters by Non Linear Algorithms’.Journal of physics D. Appl. Phys, Vol. 16, pp. 2547 – 2558, 1983. [Google Scholar] [Crossref]

9. J.H. Eckstien, ‘Detailed Modeling of photovoltaic Components’, MS Thesis, Solar Energy Laboratory, University of Wisconsin, Madison, 1990. [Google Scholar] [Crossref]

10. J.M. Enrique, E. Duran, M. Sidrach de Cardona, J.M. Andujar, M.A. Bohorquez and J.Carratero,’A New Approach to Obtain I-V and P-V Curves of Photovoltaic Modules by Using DC/DC Converters’, Rec. IEEE Photovoltaic Specialist Conference, pp. 1769 – 1722, 2005. [Google Scholar] [Crossref]

11. Y.C. Kuo, T.J. Liang and J.F. Chen,’Novel Maximum-Power-Point-Tracking Controller for Photovoltaic Energy Conversion System’, IEEE Transaction on Industrial Electronics, Vol.48, N°3, pp. 594 – 601,2001. [Google Scholar] [Crossref]

12. J.P. Charles, M. Abdelkhrim , Y.H. Muoy and P. Mialhe, ‘A Practical Method of Analysis of the Current-Voltage Characteristics of Solar Cells’, Vol. 4, N°2 , 169 – 178, 1981 . [Google Scholar] [Crossref]

Metrics

Views & Downloads

Similar Articles